Common problems and solutions for power adapters.adapter wholesale

　　Common faults and maintenance methods of power adapter 1. Line fault Line fault, including the power cord is damaged and not energized, the contact port is oxidized and the contact is poor. Focus on checking whether the input line and output line are energized. If the line is faulty, it can be solved by replacing the power cord.

　　2. The output voltage is too low. The following are the main reasons for the low output voltage: 1 Switching power supply load short-circuit failure (especially DC/DC converter short-circuit or poor performance, etc.). At this time, first disconnect all loads of the switching power supply circuit. Check whether the switching power supply circuit is faulty or the load circuit is faulty. If the load circuit is disconnected and the voltage output is normal, it means that the load is too heavy; or it is still abnormal, it means that the switching power supply circuit is faulty. 2 The failure of the filter capacitor or rectifier diode at the output voltage end can be judged by the replacement method. 3 The performance of the switching tube is degraded, which causes the switching tube to fail to conduct normally, which increases the internal resistance of the power supply and reduces the load capacity. 4 Poor switching transformer not only causes the output voltage to drop, but also causes insufficient excitation of the switching tube and thus damages the switching tube. The 5300V filter capacitor is bad, resulting in poor load carrying capacity of the power supply, and the output voltage will drop as soon as the load is connected.

　　3. The output voltage is too high. The output voltage is too high, which generally comes from the voltage stabilization sampling and voltage stabilization control circuit. In the closed control loop composed of DC output, sampling resistor, error sampling amplifier such as TL431, optocoupler, power control chip and other circuits, any one of the components will cause the output voltage to rise.

　　4. The fuse is normal and no output voltage. The fuse is normal and no output voltage indicates that the switching power supply is not working or has entered a protection state. The first step is to check the value of the startup voltage of the startup pin of the power control chip. If there is no startup voltage or the startup voltage is too low, check whether the external components of the startup pin and the startup resistor are leaking. If the power control chip is normal, the fault can be quickly found through the above monitoring. If there is a starting voltage, measure whether there is a high and low level jump at the output terminal of the control chip at the moment of power-on. If there is no jump, it means that the control chip is damaged, the peripheral oscillation circuit components are damaged, or the protection circuit is faulty. Control by replacement Chips, check the peripheral components, and check them one by one; if they are changing, most of them are bad or damaged switch tubes.

　　5. Fuse burned out or blown up. Mainly check the rectifier bridge, diodes, switch tubes, and large filter capacitors on 300 volts. It may cause the insurance to burn and turn black, or it may be caused by a problem with the anti-interference circuit. Special attention should be paid to the fact that the fuse is burnt due to the breakdown of the switch tube, which usually burns the power control chip and the current detection resistor. The thermistor is also easy to burn out along with the insurance. The common faults and maintenance of the power adapter are here. In addition, we should pay attention to the daily maintenance and maintenance of the power adapter, which can reduce the occurrence of failures and effectively extend the service life.

Read recommendations:

Switching power adapter 150~264VAC to DC adaptor for Audio video and IT equipment

AC-DC Power Module 10W High Power Switching Power Supply Board 90V-264V

Low power Indian hot selling power adapter 5W

What safety regulations need to be paid attention to in switching power supplies?

The difference between charger, switching power supply and power adapter.dc power adapters price